The use of silver as a selective precipitant for I in radioactive waste management

¹²⁹I is one of the more hazardous nuclides occurring in radioactive waste. In the form of I⁻, its most likely speciation, it is poorly sorbed on most geologic media. Several workers have suggested the use of silver to precipitate I⁻ as the insoluble AgI, in a cemented waste form, or as a “getter”. The efficacy of this procedure is examined by experiment, in conjunction with thermodynamic predictions.The addition of AgNO₃ to Portland cement leads to coprecipitation with C-S-H, with low Ag solubilities ( 10 μmg/L); 2–;3 orders of magnitude lower than predicted (from Ag₂O). AgI is stable in these matrices, with low aqueous I concentrations (<2 mg/L). In 85% BFS-15% OPC pastes, AgI is unstable due to redox and complexation reactions, with much I⁻ passing into solution; concentrations up to 900 mg/L were observed. It is shown that repository conditions, on closure, are also likely to induce solubilisation of I⁻ from AgI. It is concluded that the use of Ag is unlikely to significantly improve the immobilisation properties of the near field for radioiodine.     

Total versus inhalable sampler comparison study for the determination of asphalt fume exposures within the road paving industry

Exposure to asphalt fumes has a threshold limit value (TLV of 0.5 mg m(-3) (benzene extractable inhalable particulate) as recommended by the American Conference of Governmental Industrial Hygienists (ACGIH). This reflects a recent change (2000) whereby two variables are different from the previous recommendation. First is a 10-fold reduction in quantity from 5 mg m(-3) to 0.5 mg m(-3). Secondly, the new TLV specifies the "inhalable" fraction as compared to what is presumed to be total particulate. To assess the impact of these changes, this study compares the differences between measurements of paving asphalt fume exposure in the field using an "inhalable" instrument versus the historically used 'total' sampler. Particle size is also examined to assist in the understanding of the aerodynamic collection differences as related to asphalt fumes and confounders. Results show that when exposures are limited to asphalt fumes, a 1:1 relationship exists between samplers, showing no statistically significant differences in benzene soluble matter (BSM). This means that for the asphalt fume ACGIH TLV, the 'total' 37-mm sampler is an equivalent method to the "inhalable" method, referred to as IOM (Institute of Occupational Medicine), and should be acceptable for use against the TLV. However, the study found that when confounders (dust or old asphalt millings) are present in the workplace, there can be significant differences between the two samplers' reported exposure. The ratio of IOM/Total was 1.37 for milling asphalt sites, 1.41 for asphalt paving over granular base, and 1.02 for asphalt over asphalt pavements.     

Passive sampling: partition coefficients for a silicone rubber reference phase

Silicone rubber sheeting can be used as a passive sampling device for hydrophobic organic contaminants in the environment to determine the available concentrations in water and sediments. Reliable sampler-water partition coefficients are required to determine the sampling rates and the dissolved contaminant concentrations in water and in sediment pore water. Log partition coefficients (logK(sr,w)) for silicone rubber-water have been estimated for 32 polycyclic aromatic hydrocarbons (PAHs), 2 deuterated PAH analogues and 32 chlorobiphenyls (CBs) using the cosolvent method, with methanol as cosolvent. Strong linear relationships were found with literature values for the corresponding log octanol-water partition coefficients (logK(ow)) for both CBs and PAHs, confirming that partitioning into the silicone rubber is strongly determined by the hydrophobicity of the compounds, which suggests logK(ow) is a good predictor of logK(sr,w) and that absorption is the main mechanism for accumulation of analytes into the silicone rubber polymer.     

Scaling relationships,individual variation and the influence of temperature on maximum swimming speed in early settled stages of the turbot Scophthalmus maximus

Escape-swimming speeds (U _max) were studied in settled turbot (Scophthalmus maximus L.) reared at 18°C. Metamorphosis was complete at 4.0 cm total length (TL). U _max scaled in proportion to TL^0.74 in fish of 0.88 5o 8.00 cm TL at 18C. The scaling relationship for U _max was similar for temperatures between 13 and 23°C and could be fitted by the model: . U _max temperature-dependent, with a Q₁₀ of 1.77 over the temperature range studied. Analysis of covariance showed that U _max for farmed turbot was 14% lower than for wild fish filmed within 2 wk of capture; 3 mo after capture the average differences in escape performance were no longer significant, which suggests that the lower escape speeds of farmed fish are due to acclimation effects and not genetic stock differences. In order to assess the individual variability of U _max, 18 wild juvenile turbot [TL=6.2±0.4 cm (Week 1) to 7.5±0.5 cm (Week 17); means±SD] were maintained in individual containers at 18°C. U _max was determined weekly for 6 wk, standardised for fish length using the scaling relationship U _max=1.46 TL ^0.74, and individuals were ranked in order of performance. Temperature was reduced after 6 wk to 13°C, resulting in a significant decline in U _max from 104.0±14.4 to 87.8±12.5 cm s^-1 (means±SD). After 3 wk at 13°C U _max had increased to a level not significantly different from that at 18°C. Kendall's coefficient of concordance showed that repeatability of ranking of the experimental U _max of individuals was maintained over a 13 wk period and through temperature change. The results demonstrate that escape-swimming speeds in juvenile turbot are repeatable, individually variable, and can be modified in response to temperature acclination.     

Temperature and development in larvae of the turbot Scophthalmus maximus

Turbot (Scophthalmus maximus L.) were reared at 12 and 16°C until 26 d after hatching. At both temperatures, starting at the neural plate stage, somites were initially formed every 75 min. Expressed as a percentage of development time (DT, fertilisation to 90% larvae hatching) somite formation occurred relatively earlier during embryogenesis at 12°C (45% DT) than at 16°C (55% DT). At 12°C, after the 32-somite stage the rate of somite formation decreased to one every 300 min. The larvae hatched after 6 d at 12°C and 3 d at 16°C at a relatively primitive stage of development, prior to the opening of the mouth and anus, with unpigmented eyes, and a straight gut. Temperature altered the relative timing of organogenesis in the larval stages. At 12°C, the following characters appeared (in this order): swimbladder>loop in the gut (at the time of yolk exhaustion)>caudal fin. In contrast, at 16°C, the caudal fin appeared at the same time as the loop in the gut. At 16°C, spines formed on the head in the region of the otic capsule at the time the swimbladder formed and the yolk was exhausted, but were absent in 12°C larvae. At both temperatures, in 1 d-old larvae the myotomes just behind the yolk-sac contained 200 inner muscle fibres (presumptive white muscle). The initial growth of inner muscle was largely due to hypertrophy, but by 26 d at 12°C and 11 d at 16°C hyperplastic growth became important, as evidenced by a significant increase in the number of small fibres (<10 m²). By 26 d the average number of inner muscle fibres had increased to 341 at 12°C and 988 at 16°C. New muscle fibres were added in distinct germinal zones at the dorsal and ventral apices of the myotomes. Metamorphosis was associated with a thickening of the superficial (presumptive red) muscle layer and the appearance of tonic muscle fibres.     

Nutrient Uptake in a Large Urban River1

Abstract: Small streams have been shown to be efficient in retaining nutrients and regulating downstream nutrient fluxes, but less is known about nutrient retention in larger rivers. We quantified nutrient uptake length and uptake velocity in a regulated urban river to determine the river’s ability to retain nutrients associated with wastewater treatment plant (WWTP) effluent. We measured net uptake of soluble reactive phosphorus (SRP), dissolved organic phosphorus, ammonium (NH₄), nitrate, and dissolved organic nitrogen in the Chattahoochee River, Atlanta, GA by following the downstream decline of nutrients and fluoride from WWTP effluent on 10 dates under low flow conditions. Uptake of all nutrients was sporadic. On many dates, there was no evidence of measurable nutrient uptake lengths within the reach; indeed, on several dates release of inorganic N and P within the sample reach led to increased nutrient export downstream. When uptake occurred, SRP uptake length was negatively correlated with total suspended solids and temperature. Uptake velocities of SRP and NH₄ in the Chattahoochee River were lower than velocities in less‐modified systems, but they were similar to those measured in other WWTP impacted systems. Lower uptake velocities indicate a diminished capacity for nutrient uptake.     

Degradation of N,N'-dibutylurea (DBU) in soils treated with only DBU and DBU-fortified benlate fungicides

N,N'-dibutylurea (DBU) is a breakdown product of benomyl [methyl 1-(butylcarbamoyl)-2-benzimidazole carbamate], the active ingredient in Benlate fungicides, and has been proposed to cause crop damage after the use of Benlate 50 DF fungicide (DuPont, Wilmington, DE). Our research focused on DBU persistence after application into soil. We assessed DBU persistence on direct application of DBU (carbonyl-(14)C) at two concentrations (0.08 and 0.8 microg DBU kg(-1)) to seven soils and two potting mixes in soil microcosms incubated at various combinations of soil water potential (-0.03 or -0.1 MPa) and temperature (23, 33, 44 degrees C). For two soils at a subset of treatment variables we assessed DBU persistence in the presence of Benlate DF and SP fungicide formulations. Parent compounds, metabolites, and (14)CO(2) were tracked using chromatographic analysis with radioassay and UV detection, liquid scintillation counting, and post-extraction oxidation of the soil. DBU degradation was primarily microbial and for most soil-treatment combinations, half-lives were less than 2 wk. DBU degradation was retarded at the lower soil water potential and enhanced at 33 degrees C. In the presence of the formulation, DBU degradation was slower for one soil type. The longest half-life observed in any case was less than 7 wk; therefore, long-term persistence of DBU applied to soils through a Benlate application is very unlikely.     

Mitigation of the Impact of Tropical Cyclones in Northern Australia through Community Capacity Enhancement

Community mitigation of hazard impact requires hazard knowledge and preparedness on the part of the members of diverse and complex communities. Longitudinal research in the tropical cyclone prone north of Australia has gathered extensive datasets on community awareness, preparedness and knowledge, in order to contribute to education campaigns and mitigation strategies. Data have been used to identify issues of vulnerability to cyclones and capacity to deal with the hazard. This has been developed as a community vulnerability and capacity model that may be applied to diverse communities in order to assess levels of capability to mitigate and deal with the cyclone hazard. The model is presented here in a simplified form as its development is evolving and ongoing.     

健康与快乐:作为可持续农业必要部分之一的动物福利

一个农业系统若要是可持续的,好的动物福利是必不可少的.尽管自从我们一开始驯养动物,对它们的健康和繁殖产生依赖,我们就一直在关注动物福利问题,但本文的焦点主要集中在自20世纪60年代以来围绕动物福利的争论的进展上.它将动物福利作为一门由一个社会关注的动物饲养方式问题演化而来的科学来呈现.而这些道德伦理上的关注使得动物福利的价值架构也必须被考虑在内.随着这一领域研究的不断发展,不同的动物福利的定义和研究实例被提出和讨论.比如,近几年来,消费者对动物友好产品(animal-friendly products)的消费方面的研究兴趣大增,一如过去的环境友好产品(environment friendly products);而这也刺激了研究重点从动物福利的实验研究转移至动物福利在实际中的应用和农场的动物福利监控上.传统上讲,这样的测量是基于资源的,比如计算最小饲养空间或者最大饲养密度,但现在的趋势是趋向于基于动物的测量,比如跛足动物的数量、身体状况等.     

Prenatal diagnosis of a de novo unbalanced translocation (4p + ) following in vitro fertilization

We report herein a de novo unbalanced chromosome translocation in a fetus resulting from in vitro fertilization technology. Prenatal diagnostic analysis of an amniotic fluid revealed a 46,XX,4p+ karyotype. The origin of the extra material on the short arm of chromosome 4 could not be identified by a variety of banding techniques. However, examination of fetal parts did reveal some dysmorphic features.